EXFO BV10 Performance Endpoint Unit - Manual (Page 29)

BV10-100 and BV10-1000 23
5 Managing BV10 Verifier on
BrixWorx
This chapter describes how to configure and use BV10 hardware on
BrixWorx. It explains the CLI commands used to communicate with the
BrixWorx registry and describes how to set up tests using the BrixWorx
user interface.
Note: When the BV10 is used in a BrixWorx environment, you must use BrixWorx
GUI rather than CLI prompt to manage the BV10 device. When you change
a reflector to run or not through the CLI, this is not updated on the BrixWorx
GUI Additional Services page. The GUI changes override the changes done
using the CLI prompt.
Configuring BV10 Verifier for BrixWorx
Registry
The BV10 Verifier must be configured before you can use it in the BrixWorx
system. Once the configuration of a BV10 Verifier is complete, you must
add it to BrixWorx just like any other Verifier.
Configure the BV10 Verifier
To configure the BV10 Verifier for use in the BrixWorx system:
1. Access the CLI prompt using Telnet or SSH. To log on to the Telnet or
SSH server, use the following login information:
Login ID:
exfo
Password: exfo123
The CLI prompt name contains the BV10 model number followed by
(DEBUG). For example:
BV10-1000 (DEBUG)>
2. To configure the IP address of the local BrixWorx registry, type the
following command:
BV10-1000 (DEBUG)> server discovery local IP address