EXFO BV10 Performance Endpoint Unit - Manual (Page 33)

Managing BV10 Verifier on BrixWorx
BV10-100 and BV10-1000 27
Configuring a Test
5. Enter the time interval at which you want the BV10 Verifier to report the
health information. See Verifier Health Information on page 28 for
more information.
6. Select Load for the tests that you want to configure on the BV10
Verifier.

For the TWAMP Light Responder test, you must enter the UDP port
value to load the test.

For Smart Loopback test, select Ethernet, Ethernet all unicast, IP,
or UDP-TCP to load the specific test.
Refer to Test Applications on page 73 for more information about the
tests that you can load on the BV10 Verifier.
7. To run the SSH or Telnet service, select Run.
The selected tests and services are loaded on the BV10 Verifier.