EXFO BV10 Performance Endpoint Unit - Manual (Page 23)

Physical Interfaces, LEDs, and Buttons
BV10-100 and BV10-1000 17
Connecting the TEST Port Interface
SFP Port (BV10-1000)
The BV10-1000 provides an optional optical port for 1000Base-SX/LX/ZX
testing capability. The optical port is a Small Form Factor Pluggable (SFP)
slot type with LC connector.
Insert an SFP module into the SFP test port slot on the BV10. Refer to
Optical Interface on page 95 for more information on supported SFP.
Carefully connect optical fibre cables to the SFP’s IN and OUT ports. To
ensure good signal quality, make sure that the optical fibre connector is
fully inserted into the optical connector port.
C
AUTION
To prevent exceeding the maximum input power level please use an
attenuator when a loopback configuration is used.