EXFO BV10 Performance Endpoint Unit - Manual (Page 65)

CLI Command Reference
BV10-100 and BV10-1000 59
Configuration Commands
General Command
Test Application smart-loopback enable|disable
smart-loopback mode ethernet-all-unicast|ethernet|ip|udp-tcp
twamp enable|disable
twamp udp-port value
udp-echo enable|disable
eth-oam enable|disable
70
70
71
71
71
72
show config
Description Displays all BV10 configuration parameters as follows:

Console:
Console in-band management
a
, Console Password
a
, Console
Timeout, Telnet
a
, Telnet Timeout, SSH
a
, and SSH Timeout

Interfaces:
LAN port:
IP Address, Subnet Mask, Gateway, Auto Speed, Speed, Duplex,
Flow, MDI, VLAN ID
TEST port:
IP Address, Subnet Mask, Gateway, Auto Speed, Speed, MDI,
Transceiver, Transceiver type, VLAN ID, VLAN Priority.

Test applications:
Smart Loopback a , Smart Loopback Mode, Ethernet OAM a ,
TWAMP
a
, TWAMP port, UDP Echo
a
Syntax show config
Subgroup Command Page