EXFO BV10 Performance Endpoint Unit - Manual (Page 37)

Introducing the BV10 CLI
BV10-100 and BV10-1000 31
Connecting to the BV10 to a Console
LAN Port
A console it connected to the BV10 (LAN port) for remote access through
the network using either Telnet or SSH session.
To use the LAN port:
1. Ensure that both your PC network interface and the BV10‘s LAN port
are connected to the same Management network. Refer to LAN Port on
page 18.
2. On your PC, run a terminal application.
3. Select Telnet or SSH connection type.
The use of Telnet server is enabled by default on the BV10.
The use of SSH server is disabled by default on the BV10 and must be
enabled as well as the password must be defined; refer respectively to
console telnet|ssh server enable|disable on page 61 and password set
password on page 61; the user name is exfo. The CLI supports SSHv2.
Encryption keys are factory generated.
4. Enter the BV10 LAN port IP address and Netmask. Default values are:
IP address: 10.10.10.10
Netmask: 255.255.0
5. Establish the connection with the BV10.