EXFO FastReporter 2 - Manual (Page 243)

Working with iOLM files
Post Processing Software 233
Customizing the Elements Table Tab
To add an element:
1. Open an iOLM or iOLM bidir file.
2. Select the section or existing element where you want to add the new
element, then from the Measurement menu, select iOLM, and Add
Element.
3. Select whether the new element will be located before or after the
element you have selected. If you are adding an element to a section,
indicate the position of the element.
4. Select the type of the new element as required.
Note: You can change the splitter ratio to 2:N, if the measurement supports it.
Note: The splitter element type is not available for iOLM bidirectional files.
5. Click OK to apply the changes or Cancel to discard them.
Note: If an element is added, an asterisk (*) is displayed in the Position and Type
columns.
Element Section
Element Section