EXFO FastReporter 2 - Manual (Page 134)

Working with OTDR Files
124 FastReporter 2
Changing OTDR Settings
3. Under Event matching tolerances, change the tolerance value for
pulses as needed.

To add a pulse, click the button, enter the pulse value, and click
OK.

To remove unwanted pulses, select the values in the Pulse list, and
click the
button.
Note: If you select more than one pulse in the list, any modification to the
thresholds will apply to all of the selected pulses.
Note: To remove all added pulses and set all tolerance values back to their
original settings, click Default Settings.
4. To apply the changes without closing the dialog box, click Apply. To
apply the changes and close the dialog box, click OK.
See Setting Macrobend Tolerances on page 118 for instructions on using
the Macrobend tolerances section on the Tolerances tab.