beautypg.com

EXFO FIP-425B/435B Fiber Inspection Probe and ConnectorMax2 Mobile User Manual

Page 55

background image

Inspecting Fiber Ends

Fiber Inspection Probe

47

Inspecting Fiber Ends

To inspect fiber ends (single fiber) in Live Video mode:
1.
Install a probe tip (see Changing the Fiber Inspection Probe Tip on

page 17).

2. Insert the fiber into the probe tip.

3. Start ConnectorMax2 Mobile if it is not already started.

4. Ensure to configure the automatic file naming (see Setting up

Autonaming on page 18).

5. Depending on the probe you are using, proceed as follows:

If you have an FIP-425B, the auto analysis and the auto centering
(enabled by default) adjust automatically.

If you have an FIP-435B, the auto analysis, the auto centering, the
auto focus (all enabled by default), and the auto capture adjust
automatically.

For more information, see Analyzing Captures on page 56.

Note: With your fingers, you can stretch to zoom in on the image of the connector

on screen and pinch to zoom out of it.

6. If the fiber end is dirty, remove it from the probe, clean it and

reinspect it.

7. Once you are satisfied with the inspection, when in high magnification

level, press and hold the image of the connector on screen.

OR

Press the Fiber Inspection Probe handset button.

8. Go to the next connector or close the application.