EXFO AXS-100 Series OTDR - Manual (Page 49)

Testing Fibers
OTDR 41
Testing in Auto Mode
8. Specify whether the unit must keep the fiber settings for all acquisitions
or not, as follows:
8a. Use the arrows to select the Keep parameters list, and then press
Enter to open it.
8b. If you want the unit to reset the settings for each acquisition,
select No.
OR
If you want the unit to always use the same parameters, select
Yes.
8c. Press Enter to confirm.
Note: Even if you configured the unit to keep the parameters, it is possible to reset
the fiber settings by selecting No, and then starting an acquisition. If
desired, you can set back the option to Yes to use the new settings for the
next acquisitions.
9. Press F
AS
T
RACE
to start the acquisition.
You can stop the acquisition at any time by pressing F
AS
T
RACE
once
again.