Elenco AM/FM Radio Kit - Manual (Page 17)

-16-
ASSEMBLY INSTRUCTIONS
Be careful to properly mount and solder all components. Diodes, transistors and electrolytic capacitors are
polarized, be sure to follow the instructions carefully so that they are not mounted backwards. Check the box
when you have completed each installation.
Wear safety goggles during all assembly stages in this manual.
Q11 - 2N3904 Transistor NPN
(see Figure J)
Q13 - JE8550 Transistor PNP
(see Figure K)
R50 - 100
Ω
¼W 5% Resistor
(brown-black-brown-gold)
TP19 - Test Point Pin
(see Figure A)
R47 - 470k
Ω
¼W 5% Resistor
(yellow-violet-yellow-gold)
R51 - 100
Ω
¼W 5% Resistor
(brown-black-brown-gold)
Q12 - 2N3906 Transistor PNP
(see Figure K)
Q14 - JE8050 Transistor NPN
(see Figure J)
TP17 - Test Point Pin
(see Figure A)
TP18 - Test Point Pin
(see Figure A)
C46 - 0.001
μ
F Discap (102)
R46 - 3.3k
Ω
¼W 5% Resistor
(orange-orange-red-gold)
D5 - 1N4148 Diode
(see Figure H)
R49 - 330 Ω ¼W 5% Resistor
(orange-orange-brown-gold)
Header (2)
(see Figure I)
TP16 - Test Point Pin
(see Figure A)
Q10 - 2N3904 Transistor NPN
(see Figure J)
C47 - 47
μ
F Lytic
(see Figure B)
R48 - 47
Ω
¼W 5% Resistor
(yellow-violet-black-gold)
'
Diode
Figure H
Band
Cathode Anode
Be sure that the band
is in the same direction
as marked on the PC
board.
NPN Transistor
Figure J
Mount so E lead is
in the arrow hole
and flat side is in
the same direction
as shown on the
top legend. Leave
1/4” between the
part and PC board.
PNP Transistor
Figure K
Mount so E lead is
in the arrow hole
and flat side is in
the same direction
as shown on the
top legend. Leave
1/4” between the
part and PC board.
Flat side
1/4”
Flat side
1/4”
Header
Figure I
Solder
Cut leads off
Top legend
(blue) side
of PC board
0.3”
Top legend
(blue) side
of PC board