Elenco Radio Controlled Black Widow - Manual

Assembly
- To prevent battery leakage: Be sure to insert batteries correctly.
- Batteries should be replaced by adult.
- Never dispose of batteries in fire as this may cause them to explode.
- Do not mix old and new batteries (replace all batteries at the same time).
- Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries (or equivalent). Only batteries of the same
or equivalent type as recommended are to be used.
- Non-rechargeable batteries are not to be recharged.
- Always remove exhausted or dead batteries from product. Remove
batteries from product that is not going to be used for a long time.
Otherwise, the batteries may leak and cause damage.
- The supply terminals are not to be short-circuited.
- Make sure battery compartment is secure.
- Do not immerse battery operated toys. Wipe clean only.
The device complies with Part 15 of the FCC rules.
Operation is subject to the following conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC ID: Q6N149EL
Battery Safety Guidelines
P38-EL267-81001000
Bring your RC Black Widow movements to life
by setting him in motion.
Press these button(s), your RC Black Widow will move:
Forward
Backward
Left Right
Turn the base unit switch to "ON".
2) Insert one 9V (6LR61) battery. 1) Open or close the cover with
a philips screwdriver.
Remote Controller:
Battery Installation
Tarantula:
2) Insert 4 size "AA" (LR6)
1.5 V batteries.
1) Open or close the cover with
a philips screwdriver.
RC Black Widow
INSTRUCTION MANUAL
Size: 290 x 210mm 雙面印（對摺）