Echelon Neuron - Manual (Page 18)

10 Dependency Utility Errors (DEP)
DEP Errors
Table 4 lists the DEP error codes.
Table 4. DEP Error Codes
DEP# Description
1 An error occurred accessing file : [DEP#1]
A system error occurred when accessing a dependency file, see the error
message for details provided as .
2 An error occurred when processing dependency information: [DEP#2]
A system error not related to file I/O occurred, see the error message for
details provided in .
3 An error occurred, but no details are available
An unknown error occurred.
You should try to clean and rebuild.
4 malformed record '' in dependency file [DEP#4]
This error denotes a malformed dependency file.
You should try to clean and rebuild.
5 file can't be referenced in dependency file (might cause build status
calculation to become incorrect). () [DEP#5]
A file cannot be referenced when being added to a dependency file, or a non-
recoverable problem occurs when investigating the file described by an
existing dependency file record. This might be caused by the file being
present but corrupt, or being locked by some other process. See
provided in the message for failure details.
You can ignore this message unless it persists; however, you should try to
perform an unconditional rebuild because the missing data could cause the
Project Make Facility to incorrectly determine the device’s build status.
6 missing separator in clause '' [DEP#6]
The dependency file is missing a separator in a key/value pair.
You should try to clean and rebuild.
7 index is unsuitable for section
A bad index value has been detected within the dependency file (see error
message for section details).
You should try to clean and rebuild.