Echelon Neuron - Manual (Page 157)

Neuron Tools Errors Guide 149
NLD# Description
505 The target chip does not support machine instruction set version
[NLD#505]
506 The target chip does not support all semaphores or interrupt sources required
by this application [NLD#506]
507 The 'enable_io_pullups' directive is ineffective; there are no I/O pullups on this
chip [NLD#507]
508 The stretched triac output model is not available with the selected firmware
image [NLD#508]
509 The target hardware UART does not support all features required by a SCI or
SPI I/O object declared in this application [NLD#509]
511 Too many network variables declared. Please check the maximum number of
NVs allowed for the firmware version being used [NLD#511]
If your device is using ver 16 or higher firmware, you can declare a
maximum of 254 network variables and 127 aliases.
If your device is using a firmware version lower than ver 16, you can
declare a maximum of 62 network variables.
512 Too many aliases declared. Please check the maximum number of aliases
allowed for the firmware version being used [NLD#512]
If your device is using ver 16 or higher firmware, you can declare a
maximum of 127 aliases.
If your device is using a firmware version lower than ver 16, you can
declare a maximum of 62 aliases.
513 The onchip service pin pull-up resistor cannot be disabled with this chip
[NLD#513]
514 Flash driver symbol not found [NLD#514]
515 Statement expansion must be turned on for this target in order to allow
debugging [NLD#515]
For Series 3100 Chips, you must enable the Expand Statements option in
the Compiler tab of the NodeBuilder Device Template Target Properties
dialog to debug this target. To open this dialog, right click the target
device, click Settings on the shortcut menu, then select the Compiler tab.