Echelon Neuron - Manual (Page 129)

Neuron Tools Errors Guide 121
NCC# Description
588 Intermixing 'pragma optimization' with deprecated codegen options for
optimization control is not recommended [NCC#588]
You should use #pragma optimization.
589 This codegen option is deprecated and may be discontinued in a future release.
Use 'pragma optimization' instead [NCC#589]
590 Your optimization preferences in source code conflict with those expressed on
the command line or the IDE, and will be ignored [NCC#590]
591 You cannot change a buffer size or count value once it has been designated
‘final.’ Consider using the ‘minimum’ modifier or eliminate the superfluous
buffer control directive [NCC#591]
592 The 'minimum' buffer size or count value exceeds a previously requested 'final'
value for the same aspect This is at the location of the ‘minimum’ request
[NCC#592]
593 The 'final' buffer size or count value doesn't meet the earlier 'minimum'
specification for the same aspect. This is at the location of the ‘final; request
[NCC#593]
594 The ‘level’ modifier is no longer supported, use ‘pulse’ or the stretchedTriac
output model instead [NCC#594]
595 This I/O object requires the 'frequency' modifier to denote the typical power line
frequency [NCC#595]
596 The specified frequency is out of range for the stretched triac I/O model
[NCC#596]
597 The ‘twostopbits’ option and the parity feature are mutually exclusive
[NCC#597]
598 The CP is declared with both 'object_disabled' and 'offline'. 'offline' has higher
priority; 'object_disabled' becomes ineffective [NCC#598]
599 The configuration network variable is declared constant, but may be updated
through network variable updates [NCC#599]
600 The 'specify_io_clock' directive has no effect unless an SCI I/O object is being
declared, and will be ignored [NCC#600]
601 I2C model modifiers cannot be repeated [NCC#601]
602 Modifiers and are mutually exclusive [NCC#602]