Echelon Neuron User Manual
Page 141
Neuron Tools Errors Guide
133
NEX#
Description
64
An image can not be exported as configured, without domain, and with a 96 bit
authentication key [NEX#64]
Exporting configured and authenticated images requires the domain to be
specified if a 96-bit authentication key is to be used. See the Neuron Chip
or Smart Transceiver data book and the
NodeBuilder FX User’s Guide
for
details about exporting configured images.
65
The currently chosen firmware does not support 96 bit authentication keys
[NEX#65]
You must choose a firmware version that supports this feature, or use a 48-
bit authentication key instead.
66
96 bit authentication keys requires two domain table entries [NEX#66]
You cannot reduce the size of the domain table to one entry (by using the
Neuron C compiler directive #pragma num_domain_entries 1 and still
export this device image using a 96-bit authentication key. You can use a
48-bit authentication key, or you must allow for both domain table entries
to be created.
67
At least one of domain ID, subnet ID, and device ID has not been specified but is
required for this export configuration [NEX#67]
The image cannot be exported as desired due to lack of data. For example,
this would occur if an image should be exported in the configured state, and
only the subnet and device ID, but no domain ID, was provided. Verify that
to specify all data required, or to specify the correct state of the exported
image.
68
The firmware does not support 96 bit authentication keys [NEX#68]
You must disable authentication, use a 48-bit authentication key, or use a
firmware version that does provide support for 96-bit authentication keys.
71
The chosen firmware does not support operation at 3.2768 or 6,5536MHz
[NEX#71]
The 6.5536 MHz clock rate is only supported in Version 14 firmware and
later.
73
The chosen combination of transceiver and Neuron model requires operation at
3.2768 or 6.5536 MHz [NEX#73]
When using the PL31x0 chip, when combined with the PL-20A or PL-20A-
LOW transceiver, you must use the 6.5536 clock rate.
For other cases, please consult your Neuron Chip or Smart Transceiver
data book.