Echelon Neuron - Manual (Page 16)

8 NodeBuilder Debugger Errors (DBG)
DBG# Description
62 Network interface must be configured to run VNI [DBG#62]
Use the control panel to select a VNI network image. The name depends on
which network interface you use. For the PCLTA-20 use: PCL10VNI. Do
not use NSIPCLTA or PCC10L7.
63 Device not found in network database [DBG#63]
Remove the device from the NodeBuilder project tree view. You can then
right-click the Devices folder, click Insert on the shortcut menu, and then
select the device you want to debug. You may have to re-drop the target
device shape with LonMaker.
64 Cannot debug this device because it is unconfigured. Use the LonMaker
Commission command to commission it and try again [DBG#64]
65 Cannot debug this device because it is applicationless. Use the LonMaker Load
command to load the application image and try again [DBG#65]
66 Cannot debug this device because it is hard-offline. Use the LonMaker Device
Manage command to put it online and try again [DBG#66]
67 Cannot debug this device because it is soft-offline Either reset it or use the
LonMaker Device Manage command to put it online [DBG#67]
68 Failed to write device memory. Please try again [DBG#68]
69 Failed to read device memory. Please try again [DBG#69]
70 A device being debugged either stopped communicating or was deleted. The
debug session will stop [DBG#70]
71 Device did not respond to Query Status command [DBG#71]
Probably not a serious problem. The device may not have responded
because of a lost packet.