3 signal connection, 3signal connection – ADLINK PCI-8258 User Manual
Page 55
Signal Connection
41
PCI-8254 / PCI-8258
3
Signal Connection
PCI-8254/PCI-8258 must connect to servo or stepper motor drive
with exclusive terminal board DIN-825-GP4. All optical isolation
circuit of mechanical relevant I/O and servo relevant I/O are set to
DIN-825-GP4 to prevent damages to primary controller
PCI-8254/PCI-8258 from any invalid signal connection to it. This
may effectively reduce difficulties and times required in replacing
controller relevant products when doing customer service
maintenance tasks. See sections below for detailed descriptions
on precautions required to connect to various mechanical I/O and
servo I/O signals. Contents:
Section 3.1:
Analog Command Signal
Section 3.2:
Pulse Command Signal
Section 3.3:
Encoder Input Signal
Section 3.4:
Emergency Stop Signal
Section 3.5:
Mechanical Limit Switch Signal
Section 3.6:
Original Position Switch Signal
Section 3.7:
In-position/Zero Speed Signal
Section 3.8:
Servo Alarm Signal
Section 3.9:
Servo On Signal
Section 3.10: Analog Input Signal
Section 3.11: Comparing Trigger Signal
Section 3.12: General Purpose Digital Input and Output Signal