1 definitions to connector, Definitions to connector, Figure 2-4 – ADLINK PCI-8258 User Manual

Page 42: Exterior of din-825-gp4

Getting Start with The Installation

2.8.1 Definitions to Connector

1. P1: This is one SCSI

100-PINS connector for

motion control signals.

2. CMA1–4: These are four

26-PINS connector for

connecting to servo

drive to do S/T mode

control and analog

control commands

output.

3. CMP1–4: These are four

26-PINS connectors for

connecting to servo

drive to do P mode

control or stepper drive

to output pulse control

commands. It may be

connected to Mitsubishi

J3A series, Yaskawa

Sigma II, III & V series,

and Panasonic MINAS

A4&A5 with exclusive

cables.

4. J1–J3: These are three

sets of 10-pins screw

lock connectors

(screwed series, Delta

A2 series, or connection

to other servo or stepper

drives with single end

open cables). It may be

connected to any analog

input signal, comparing

trigger signal, plus/minus limit switch and homing signal '.

5. J4: This is one 8-PINS connector for connecting to Brake

Signal.

6. J5: This is one 5-PINS connector for connecting to

terminal board main power and emergency stop signals.

IOIF4

IOIF1

J2 J1

IOIF3

IOIF2

CMA1

CMA2

CMA3

CMA4

CMP1

CMP2

CMP3

CMP4

CN1

Figure 2-4: Exterior of DIN-825-GP4

This manual is related to the following products:

PCI-8254