ADLINK AMP-208C - Manual (Page 39)

Getting Start with The Installation 25
AMP-204C / AMP-208C
2.8 Exclusive Board - DIN-825-GP4
The DIN-825-GP4 terminal board is designed for PCI-8254 /
PCI-8258 and AMP-204C / AMP-208C exclusively. It connects
with market available servo drives with special cables, e.g.
Mitsubishi's J3A and Yaskawa's Sigma V series, or third party's
servo or stepper drives with single end open cables.
Figure 2-3: Exterior of DIN-825-GP4
CAUTION
The DIN-825-GP4 board supports both PCI-8254 / PCI-8258
and AMP-204C / AMP-208C. DO NOT connect it to other
ADLINK's motion controllers as it may be damaged.
Additional 16 Digital
output signals Motion I/O signals
Additional 16 Digital
input signals
I/O connector
(to PCI board)
Power &
EMG signal
Main connector
(to PCI board)
Brake signal Analog commands
(Torque Control)
Pulse commands
(Position Control)
Analog input signals Laser control signals