ADLINK AMP-208C - Manual (Page 22)

8 Introduction
1.2 Software Support
1.2.1 Software Support Library
AMP-204C / AMP-208C supports Windows XP/7 32/64 bit
operating system and provides a complete function library and
DLL files for easy application development by users.
1.2.2 MotionCreatorPro 2
MotionCreatorPro 2 is a user interface exclusively developed for
ADLINK motion control products in common Windows
environment. You may easily set up card and axis parameters with
the help of MotionCreatorPro 2. Its Setup Wizard guides you
through the hardware installation and wiring as well as single-axis
manipulation in couple of minutes. MotionCreatorPro 2 not only
effectively reduces your development time but also enables you to
concurrently validate the overall mechanism and electric design
with all its single axis and interpolation motion operation pages.
1.3 Terminal Board
ADLINK's exclusive terminal board DIN-825-GP4 for
AMP-204C/208C can connect with market available servo drivers
with special cables, e.g. Mitsubishi's J3A and Yaskawa's Sigma V
series, or with third party's servo or stepper drivers by single
ended open cables. Brands with exclusive cables support are
listed below:
Pulse command:
Table 1-1: Cross-reference table of exclusive cables for pulse servo drive
Cable Supported brands
HSL-4XMO-DM
Mitsubishi J2S series
4XMO-DM-J3
Mitsubishi J3A series
HSL-4XMO-DP
Panasonic A4 and A5 series
HSL-4XMO-DY
Yaskawa Sigma V series
4XMO-DA Delta A2 series
4XMO-OPEN
General purpose