D-Link DCS-6620G - Manual (Page 43)

43
DCS-6620G User’s Manual
D-Link Systems, Inc.
Using the DCS-6620G with an Internet Browser
Configuration > Advanced > Mail & FTP (continued)
Click Apply to make
changes effective
Invalid settings may cause the DCS-6620G to not respond. Change the configuration settings
only if necessary. Consult with your network administrator or your Internet Service Provider
(ISP) if you do not have the necessary information. If you cannot connect to the camera,
refer to page 132 for camera
reset and restore factory settings procedures.
Granted folder on the external FTP server. The string must
conform to the external FTP server. Some FTP servers cannot
accept a preceding slash symbol before the path if there is no
virtual path mapping. Refer to the instructions of the external
FTP server for details. The folder privilege must be open for
upload.
If the DCS-6620G is located inside a network that is protected by
a firewall, a data connection for FTP may be prohibited. Passive
mode FTP can bypass this rule and allow the uploading of
snapshots. If the passive mode is selected, the DCS-6620G can
automatically attempt to upload in active mode if the external
FTP server does not support passive mode.
The domain name or IP address of the external FTP server.
Note that the 2nd FTP server will only be used if the 1st FTP
is unavailable. If image upload to the 1st FTP is successful,
no attempts will be made to connect to the 2nd FTP server.
The port to access the backup FTP server.
Granted user name on the backup FTP server.
Granted password on the backup FTP server.
Granted folder on the backup FTP server.
Passive mode setting for the backup FTP server.
1st FTP remote folder:
Primary FTP Passive
Mode:
2nd FTP server:
2nd FTP server port:
2nd FTP user name:
2nd FTP password:
2nd FTP remote folder:
Secondary FTP Passive
Mode: