D-Link DCS-6620G - Manual (Page 132)

132
DCS-6620G User’s Manual
D-Link Systems, Inc.
Reset and Restore
There is a button hidden in the pinhole beside the Ethernet socket. It is used to reset
the system or restore the factory default settings. Sometimes resetting the DCS-6620G
will return the system back to a normal state. If the system still has problems after
reset, restore the factory settings and install again:
RESET: 1.
2.
3.
RESTORE: 1.
2.
3.
Reset and Restore
Restoring the factory defaults will result in the
loss of any previous settings and will require
running the Installation Wizard to return the
DCS-6620G to a normal state.
The LED on the front of the camera will begin blinking red and
green.
Lightly insert a paper clip (or a similar sized tool) into the reset
hole on the back of the camera, press lightly and then release
the button.
Insert the paperclip or other tool and press on the button
continuously.
Wait for the LED on the front of the camera to blink red and green
and hold the button for 10 seconds.
Withdraw the tool after the second cycle of the LED blinking and
a factory restore has been completed.
When the LED stops the blinking the reset has completed.
Reset button