Volume, Super t-bass system, Bbe system – Aiwa NSX-A508 User Manual
Page 7: To dim the illumination of the display, Using the headphones, Sound adjustment during recording
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SOUND
■ T-BASS
■SHIFT
■VOLUME
VOLUME
Turn VOLUME on the main unit, or press VOLUME on the
remote controi.
The volume level is displayed as a number from 0 to MAX (50).
The volume level is automatically set to 20 when the power is
turned off with the volume level set to 21 or more.
SUPER T-BASS SYSTEM
The T-BASS system enhances the realism of low-frequency
sound.
Press T-BASS.
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
T-BASS
I
L ■ -TT J
To select with the remote control
press
T-BASS
while pressing
SHIFT.
' Low frequency sound may be distorted when the T-BASS
system is used for a disc or tape in which low frequency sound
is originally emphasized. In this case, cancel the T-BASS
system.
’When playing back a tape recorded with BBE, it is
recommended that BBE be set to off to avoid distorted high
frequency sound.
W
z
o
p
<
cc
<
Q.
UJ
m
a.
D
o
M
BBE SYSTEM
The BBE system enhances the clarity of high-frequency sound.
It also enriches the Karaoke function to make your voice sound
clear and pleasant.
Press BBE.
Each time it is pressed, the level changes. Select one of the
three levels, or the off position to suit your preference.
BBE
To dim the illumination of the display
1
Press
DISP
twice so that “DIMMER” is displayed.
2
Within 4 seconds, turn
MULTI JOG
to select the dimmer mode
as follows.
DIMMER 0— DIMMER 1 — DIMMER 2— DIMMER 3
DIMMER 0:
The normal display
DIMMER 1:
The illumination of the display is dimmer than
usual.
DIMMER 2:
The illumination of the display is dimmer than
DIMMER 1.
DIMMER 3:
The illumination of the display is dimmer than
DIMMER 2, and the spectrum analyzer and the illumination
on the buttons light off.
Using the headphones
Connect headphones to the
PHONES
jack with a standard stereo
plug (
06.3
mm,
'U
inch).
No sound is output from the speakers while the headphones are
plugged in.
Sound adjustment during recording
The output volume and tone (except BBE) of the speakers or
headphones are freely varied without affecting the level of the
recording.
ENGLISH