Aiwa NSX-A508 - Manual (Page 19)

CLOCK AND TIMER
1,2,3
J-2,3
i f —
• r - ^
M : N \ i
f
----------
MULTI JOG-
ENTER­
II-------
(==]
T
lU
o
<
oc
<
a
DC
UJ
I
H
Q
Z
<
u
o
1 Press CLOCK, then press II SET within 4
seconds.
Mpri.2;;№
___________________ N
When using the remote control
Press CLOCK while pressing SHIFT, then press 11 SET within
4 seconds.
2 Press ◄◄ DOWN or ►► UP to designate the
hour, then press II SET.
The hour stops flashing and the minute starts flashing.
3 Press ◄◄ DOWN or ►► UP to designate the
minute, then press II SET.
The minute stops flashing on the display and the clock starts
from 00 seconds.
To display the current time
Press CLOCK. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK and then press ■ within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
’ ENTER is also available instead of II SET.
' MULTI JOG is also available instead of and I
The unit can be turned off automatically at a specified time.
Use the remote control. '
1 Press SLEEP while pressing SHIFT.
- - ^ N
2 Within 4 seconds, press ◄◄ or ►► to specify
the time until the power is turned off.
Each time the button is pressed, the time Changes between 5
and 240 minutes in 5-minute steps.
Specified time
S/...FFP 70 ...
.bT____________________ N
To check the time remaining until the power is turned off
Press SLEEP once while pressing SHIFT. The remaining time
is displayed for 4 seconds.
To cancel the sleep timer
Press SLEEP twice while pressing SHIFT so that “SLEEP oFF”
appears on the display.
' MULTI JOG is also available instead of ■ ' and I
ENGLISH
18