6, commands to set parameters – A&D Weighing Indicator AD-4329 User Manual
Page 52
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
12.1.6, Commands to Set Parameters
Set Preset Tare
The preset tare value is set The decimal point is not necessary because of according
to display.
Template PT, [value]
Command
Reply
iPil ,1+12 1
iPiTi , + 2|l 3
Set Upper Limit Value
Set the upper limit value of the upper/lower limit comparison. The decimal point is not
necessary because of according to display.
Template Hi, [value]
Command
Reply
I
h
I
i
I .klsiolo
oi^lvi
|
h
I
TRs
OIOIOIC
r
NI
Set Lower Limit Value
Set the lower limit value of the upper/lower limit comparison. The decimal pojnt is not
necessary because of according to display.
Templete LO, [value]
Comrnand 1
l
I
o
! ,
I -is! 61 Oj^i^
Reply I L|ol, I ~i 5l6|Oi%Nl
Set Final Value
Set the final value of the setpoint comparison. The decimal point is not necessary
because of according to display.
Templete SO, [value]
Command 1 sJ Qi > l+i 7T^dio[^i^l
Reply isloU+l7iOjoioicRiM
Set Free Fall Value
Set the free fall value of the setpoint comparison. The decimal point is not necessary
because of according to display.
Templete S1, [value]
Command Islij .i4-ii}6io|%M
Reply [
SI
iieioNM
Set Preliminary Value
Set the preliminary value of the setpoint comparison. The decimal point is not
necessary because of according to display.
Template S2, [value]
Command rsT2| . kl si'sloi^M
■ Reply rsITi,ki8is|om
,12. RS-232C Interface
PSQ® 48
AD-4329 Weighing Indicator