Exiting the calibration mode – A&D Weighing Indicator AD-4329 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Digital Input
Siep16 Pressing the ^ key, a stored input voltage
parameter of the span is displayed in the unit
of mVA/. Adjust the input voltage using the
following keys.
>Tkey.......The key to select a figure. , "
' key..... The key to select a number.
key.....The key to store the span parameter
and proceed to step 17.
A
MQPEl key..The key not to change parameter and
go back to step 4.
CALj key.... The key not to change parameter and
proceed to step 17.
5.2.8. Exiting the Calibration Mode
Step17 Check the j
C8L End j
display.
Use the following keys.
CALj key......Parameters are stored in the indicator
is displayed. Proceed to
and
End
[8 Í End
CAL
End
step 18.
¡MOD^ key.. The key to memorize parameters
temporariiy. Proceed to the "Minimum
Division Selection".
Press and hold the iNEiyQROSSj key and press the ICAll key
All parameters are not changed,
is displayed and the
1/0
OPRSIB
Turn display off
CFInCEL
calibration mode is finished.
Stepi 8 Press the jOperate/Standbyl key to turn the display off.
AD-4329 Weighing Indicator
Page 17
5. Calibration