A&D Weighing Indicator AD-4329 - Manual (Page 42)

9.3.3, Setting the Parameters of Setpoint Comparison
step 1 Press the loperate/Standb^ key to turn the display off.
Step 2 Press and hold the I print I key and press the
lOperate/Standbvl key to display .15^1: 0 for two seconds
Step 3 Set the "Final" using the following keys.
>] key.....The key to select a figure.
"7C| key..... The key to select a number.
I
+/-
1
key.....The key to select plus or minus,
key..... The key to store the parameter and
proceed to next step.
MOPEj key ..The key not to change the parameter
and proceed to next step.
Stsp 4 Sit: I is displayed for two seconds.
Set the "Free fall" using the same keys as steps.
5 SEt P is displayed for two seconds.
Set the "Preliminary" using the same keys as step3.
Step 6 5Et 3 is displayed for two seconds.
Set the "Zero band" using the same keys as step3.
Step 7 Turn the display off using the jOpemte/Standb^ key.
Display off
Q pm
.
Press and hold
Press
!/(!)
OPRÌSTB
2seconds Sft
0
Pinal
Mel/S/G
iTiGPOSS 4*/—
ZERO
>
TARE
soon
Q
PSiflT
Sit I
MBIG
•K>
new ZERO TARE
>
ys
Free fall
2seconds
100
Q
PRlUr
SEt i I
Nsl/B/G •»TV
eiGRGSS ZERO TARE
•4*/— >
Prerimtnary
SÙQ
Q
PRiilT
2seconds
SEt E
ZERO TARE
SO
Zero band. 0
PRiMT
l/C!)
OPR/STBi
Display of!
9.3. Setpoint Comparison Page 40 AD-4329 Weighing Indicator