A&D Weighing Indicator AD-4329 - Manual (Page 35)

Tare
a The function is used to display a net value with the container weight subtracted from
the total weight, if you put an object into a container to weigh it.
o There are two methods for the "weighing tare weight" and "digital input of tare weight".
□ Using the RS-232C Interface, you can perform digital input from external equipment.
Caution □ When turning the display off with if -05 I, the tare value is cleared.
□ When turning the power off, the tare value is cleared.
7.1.1. Weighing Tare
Operation Put the tare on the weighing unit. Press the [TAREl key to store the tare weight
after the MD mark turns off. The dispaly changes to net.
Caution o When displaying a negative gross value, tare can not be used.
7.1.2. Digital Input
Caution □ The input value Is rounded off to the unit of division (weighing interval).
□ In case of rr-05 l(power-onzero), the display value will be zeroed when
turning the display on.
□ When using a multi-interval scale, usable input range is the first range.
Q In case of if-05 /(To inhibit preset tare), preset tare can not be used.
Step 1 Press the [PRESET TARg key to display the stored tare value.
When tare is cleared or is not used, the value is zero.
Step 2 Enter a new tare value using the following keys.
S ............... . The key to select a figure.
7n key............. The key to select a number,
key.......... The key to store a new tare vaiue.
The net is displayed.
7.1.3, Clearing Tare
□ When pressing the [TAREj key while gross is zero, tare is cleared and gross Is
displayed.
□ When zeroing with the IZEROl key, tare is cleared.
AD-4329 Weighing Indicator
Page 33 7, Tare