Cabletron Systems HSIM-A6DP- - Manual (Page 44)

Chapter 3: Local Management
3-18 HSIM-A6DP User’s Guide
TEST PORTS NOW (Command)
This command, when performed, instructs the HSIM-A6DP to perform
an APIM redundancy test immediately. When the test is completed, the
results are displayed in the Results of previous test field.
RESET TO FACTORY DEFAULTS (Command)
This command, when performed, resets all the fields in the ATM
Redundancy Configuration screen to their default settings.
SAVE (Command)
This command saves all changes to memory.
3.8.2 Setting the Redundancy Status
To set the Redundancy Status, perform the following steps:
1. Use the arrow keys to highlight the Redundancy Status field.
2. Press the SPACE bar to toggle between the choices until the desired
mode displays ([Enabled] or [Disabled]).
3. Use the arrow keys to highlight the SAVE command at the bottom of
the screen and press ENTER. The changes are saved to memory.
3.8.3 Setting the Primary Port
To set the Primary port, perform the following steps:
1. Use the arrow keys to highlight the Primary port field.
2. Press the SPACE bar to toggle between the choices until the desired
port displays (1 or 2).
3. Use the arrow keys to highlight the SAVE command at the bottom of
the screen and press ENTER. The changes are saved to memory.
3.8.4 Setting the Active Port
To set the Active port, perform the following steps:
1. Use the arrow keys to highlight the Active port field.
2. Press the SPACE bar to toggle between the choices until the desired
port displays (1 or 2).