Cabletron Systems HSIM-A6DP- - Manual (Page 20)

Chapter 2: Installation
2-2 HSIM-A6DP User’s Guide
2.2 INSTALLING APIMs
To install an APIM into the HSIM-A6DP, refer to Figure 2-1 and
Figure 2-2 and perform the following steps:
1. Attach the antistatic wrist strap (refer to the instructions on the
antistatic wrist strap package).
2. Remove and save the three faceplate screws attaching the faceplate to
the HSIM. Remove the HSIM faceplate.
3. Remove and save the three screws from the HSIM standoffs. Remove
the APIM coverplate.
4. Insert the APIM connector into the HSIM connector pins.
Figure 2-1 Removing the APIM Coverplate
Only qualified personnel should install or service this unit.
207733
APIM
Coverplate
Standoff Screws
HSIM Standoffs