Ariens 932 Series - Manual (Page 60)

Attachments
r
.7 Rotary Brush Installation
NOTE: Install air cleaner. Refer to Attachment
Air Cleaner Installation Section of this manuai.
Remove auger/impeiier housing, auger/impeller,
and auger/impeller gearcase from tractor
frame. Refer to Auger/impeller Section of this
manual.
Remove belt guard from rotary brush.
Position attachment drive belt on drive puiiey
and instail Rotary Brush to tractor frame using
four screws from Auger/Impelier housing.
Check alignment of attachment belt and move
drive puiiey on rotary brush in or out as re­
quired to aiign with engine puiiey. Repiace beit
guard.
9.8 Rotary Brush Lubrication
Grease zerk fitting on each of two spindie
ousings every 25 hours of operation or once
each season. Use Ariens Multi-Purpose Grease
No. 000150.
9.9 Rotary Brush Adjustment
Adjust caster wheeis by loosening setscrew
on each side of brush and sliding caster wheei
support up or down as required. Casters must
be adjusted so brush cleans properly, but does
not “dive” into grass and stall tractor.
To replace attachment drive belt, loosen cap
screws in siotted hoies on each side of brush
frame, siide brush backward and remove beit.
Place new belt over right hand caster wheel,
around drive puiiey, across idiers and onto
spindie puiiey. Make sure top idler runs on
back of belt and lower idler runs on front of
belt.
Tighten beit by puiiing brush forward and
tightening cap screws on each side of brush
frame.
To tighten drive chain, loosen cap screws
securing spindie housing to brush frame, slide
spindie housing to side to tighten chain and
tighten cap screws.
Appiy a few drops of oil to chain, idier bearings
and caster wheei pivots every 25 hours or once
each season.
r
10
3. Caster Wheel Support
4. Setscrew
5. Right Hand Caster Wheel 8. Spindle Pulley
9. Drive Chain
10. Drive Pulley
9-9