2 attachment drive belt, 3 traction drive beit, 2 attachment drive belt -6 – Ariens 932 Series User Manual

Page 25: 3 traction drive belt -6, Belt drive

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Belt Drive

4.1 Introduction

WARNING: Remove wire from spark plug
before attempting any repair or adjust
ment procedures.

When unit is tipped onto housing, remove

enough fuel so that no spillage will occur,
block securely and remove bottom cover.

WARNING: Gasoline is highly flammable
and its vapors are explosive. Handle with
care.

NOTE: Auger/Impeller Housing and frame must
be tipped apart to perform repairs in this sec
tion. Refer to Auger/Impeller Section of this
manual.

CAUTION: After new belts have been
installed, Clutches must be adjusted
per instructions in Handiebars and
Ciutch Controls Section to insure pro
per function.

1. Engine Puiiey
2. Attachment Puiiey
3. Attachment Drive Beit
4. Attachment Brake

Figure 4-4: Drive Beit (Auger PropeNed Modeis)

4.2 Attachment Drive Belt

Remove attachment drive belt from pulley

(hold brake away from belt).

Place attachment drive belt on auger/impeller
pulley, and while holding brake out of way, tip
unit together. Assemble unit in reverse order.

NOTE: Make sure pulleys align. If alignment is
necessary, loosen attachment pulley set

screws, reposition pulley and tighten set
screws.

WARNING: When clutch is engaged, im

peller brake disengages. If brake is not
1/16 to 1/8” from belt when disengaged,
refer to Attachment Clutch/Impeller
Brake Section.

4.3 Traction Drive Beit

1. Attachment Brake
2. Attachment Pulley
3. Attachment Drive Belt
4. Attachment Idler

Engine Attachment

Pulley

Engine Drive Pulley
Drive Belt
Traction Idler

Figure 4-5: Drive Belts (Wheel Driven Models)

Pull idler away from belt and remove belt from
idler pulley, engine and drive pulley (it may be
necessary to turn engine pulley using rewind
starter).

NOTE: To gain clearance, engage traction

clutch and pull back attachment idler arm
clevis pin.

Replace traction drive belt in reverse order
making sure pulleys align. If alignment is
necessary, loosen engine pulley set screws,
reposition pulley and tighten set screws.

Check alignment of attachment drive pulley
and align according to above instructions if

necessary.

4-6