Ariens 932 Series - Manual (Page 3)

Introduction
I
I
How To Use Your Service Manual
The Ariens Service manual is arranged for
quick, easy reference and is divided into
numerical sections. Each section is then divid­
ed into sub-sections. To use this manual pro­
ceed as follows:
Refer to the index to determine section within
Which desired information will be contained
and proceed to front of that section for its
Table of Contents.
Locate subject desired. Page number is listed
across from subject and consists of section
number and page number.
NOTE: Read all information for servicing a part
or system before repair work is started to avoid
needless disassembly.
Preparation For Service
Proper preparation is very important for effi­
cient service work. A clean work area at the
start of each job will allow you to perform the
repair as easily and quickly as possible, and
reduce incidences of misplaced tools and
parts. A sno-thro that is excessively dirty
should be cleaned before work starts. Cleaning
will occasionally uncover trouble sources.
Tools, instruments and parts needed for the
job should be gathered before work is started.
Interrupting a job to locate tools or parts is a
needless delay.
Service Buiietins
In addition to the information contained in this
Ariens Service Manual, Ariens Service
Bulletins are issued to Ariens Dealers from
time to time, which cover interim engineering
changes and supplementary information. Ser­
vice Bulletins should be consulted to complete
information on models covered by this manual.
Replacement Parts
When replacement parts are required, use only
genuine Ariens parts. Failure to do so may
result in product malfunction and possible in­
jury to operator and/or bystander.
NOTE: All references to “Left”, “Right”,
“Front” and “Back” are given from operators
position.
NOTE: The descriptions and specifications
contained in this manual were in effect at the
time the manual was approved for printing.
Ariens company reserves the right to discon­
tinue models without notice and without incur­
ring obligation. The equipment identified as
either standard or optional and the various il­
lustrations may not all be applicable to your
unit. If you have questions, always check with
your Ariens dealer.
»
©Ariens 1987
RM-932
Part No. 000128A
Printed in U.S.A. 11-87