Ariens 932 Series - Manual (Page 17)

Speed Selector and Wheels
3.1 Speed Selector Removal
On models with lower speed selector, remove
two taptites securing shift handie retainer to
quadrant and remove retainer.
Remove taptite securing speed selector to
quadrant. Remove taptites securing quadrant
to frame and remove speed selector and
quadrant from frame.
Inspect parts for wear or replacement
assemble using reverse procedure.
and
1. Taptite
2. Speed Selector Retainer
3. Quadrant
4. Grip
5. Speed Selector
6. Retainer and Nut
Figure 3-2: Speed Selector
(Models with lower speed selector)
On models with Speed Seiector on handlebar
panel, remove nut, bolt, washer, spring and
spacer attaching Speed Selector to handlebar
panel and remove Speed Selector. Remove
gear selector rod from Speed Selector.
Remove lower nut from bottom of Speed
Selector rod and remove rod from rod adapter.
Inspect parts for wear or replacement.
3.2 Speed Selector Adjustment
(Models with Speed Selector
mounted to handlebar panel)
NOTE: Refer to Handlebars and Clutch Con­
trols Section for handlebar height adjustment
procedure.
On models with adjustabie handlebars, after
adjusting handlebar height (from about mid to
low standard setting), loosen nuts on Speed
Selector rod at rod adapter enough to allow
Speed Selector to be positioned in first (1)
speed slot. Position Speed Selector arm
parallel with top of frame and tighten nuts to
lock rod in position.
To achieve maximum safe operating height of
handlebar utilizing standard rod, place Speed
Selector in first (1) speed, position lower nut to
end of rod (with threads fuliy engaged) and
lock rod in position with top nut. Raise
handlebar until Speed Selector arm is parallel
to top of frame and secure handlebar.
14
/\ii
12
13
^ 12
10
1. Cap Screw
2. Washer
3. Spacer
4. Compression Spring
5. Speed Selector
6. Grip
7. Push Nut
8. Hole Plug
9. Shift Pivot
10. Lock Nut
11. Shift Rod
12. Lock Nut
13. Swivel
14. Cap
Figure 3-3: Speed Selector
(Models with Speed Selector on handlebar
panel)
3-2