Cabletron Systems 2M46 - Manual (Page 76)

Chapter 2: LM Security Screens for 2E43-51/2E43-51R Devices
2-2 Local Management Supplement
The following introduces each screen that is accessible from the Repeater
Configuration Menu screen.
REPEATER LEVEL SECURITY CONFIGURATION
Used to set the state of security of all ports on each connector,
simultaneously. The ports can be set to receive all frames (NonSecure
state), lock on the source address of the next frame received
(LockOnNext), or lock on the address of the last frame received
(LockedOnAddr). For details, refer to
Section 2.2 .
PORT LEVEL SECURITY CONFIGURATION
Used to set the security for each port of a connector, individually. For
details, refer to
Section 2.3 .
2.2 REPEATER LEVEL SECURITY CONFIGURATION
The Repeater Level Security Configuration screen, Figure 2-2 , is used to
set the state of security according to connector. All ports on a connector
can be set to receive all frames (NonSecure state), lock on the source
address of the next frame received (LockOnNext), or lock on the source
address of the last frame received (LockedOnAddr). When either of the
last two options are set, the switch can be set to enable or disable the
reception of frames and send or not send traps when an intruder is
detected.
To access the Repeater Level Security Configuration screen, use the arrow
keys to highlight the REPEATER LEVEL SECURITY
CONFIGURATION menu item on the Repeater Configuration Menu
screen and press ENTER. The Repeater Level Security Configuration
screen displays.