Cabletron Systems 2M46 - Manual (Page 103)

GARP Operation Status Screen
Local Management Supplement 4-5
GVRP (Toggle)
Sets the port to operate as a GVRP-aware port. The setting is only valid if
the GVRP Protocol field near the bottom of the screen is set to Enable.
The GMRP field setting toggles between Y (yes) and N (no). The default
is “Y”.
To set the port, refer to Section 4.3.1 .
Set All Ports (Selectable)
Sets all ports to the same setting by selecting one of the following:
• GMRP Enable All – Sets all ports as GMRP-aware ports. All ports are
set to Y under GMRP.
• GMRP Disable All – Sets all ports as not GMRP-aware ports. All
ports are set to N under GMRP.
• GVRP Enable All – Sets all ports as GVRP-aware ports. All ports are
set to Y under GVRP.
• GVRP Disable All – Sets all ports as not GVRP-aware ports. All ports
are set to N under GVRP.
• Enable All – Sets all ports to Y for both GMRP and GVRP.
• Disable All – Sets all ports to N for both GMRP and GVRP.
To set all ports, refer to Section 4.3.1 .
GMRP Protocol (Toggle)
Enables or disables the GMRP Protocol on the switch.
When set to Enable, all port settings are valid for GMRP, enabling those
ports to send/receive frames to other GMRP-aware switches. Disable
makes the port settings invalid.
The default setting is “Disable”.
To enable or disable the protocol, refer to Section 4.3.2 .