Cabletron Systems 2M46 - Manual (Page 32)

Chapter 1: Changes to Local Management Screens
1-16 Local Management Supplement
PORT REDIRECT CONFIGURATION
Used to access the Redirect Configuration Menu screen, which provides
access to the Port Redirect Configuration and VLAN Redirect
Configuration screens. For details, refer to
Section 1.10 .
BROADCAST SUPPRESSION CONFIGURATION
Used to set a desired limit of received broadcast frames that are forwarded
out other interfaces. For details, refer to
Section 1.13 .
REPEATER CONFIGURATION MENU
Used to access the repeater configuration screens, which enable the user
to configure operations and security at the connector and port level.
In the 2E43-51and 2E43-51R devices, the screens are the Repeater Level
Security Configuration and Port Level Security Configuration screens.
In the 2H23-50R and 2H33-37R devices, the screens are the Repeater
Configuration Menu screen and its two subordinate screens, Repeater
Level Security Configuration and Port Level Security Configuration
screens.
For details on setting the security on the repeater devices, refer to
Section 1.14 .
1.7 ETHERNET FULL DUPLEX CONFIGURATION
SCREEN
The Ethernet Full Duplex Configuration screen, Figure 1-8 , allows the
user to set the front panel ports, individually or all at once, to either
Standard Ethernet or Full Duplex operation, and monitor each port to see
whether or not it is enabled and linked to another Ethernet device. Refer
to
Section 1.7.1 to set the Operation Mode.
To access the Ethernet Full Duplex Configuration screen from the Port
Configuration Menu screen, use the arrow keys to highlight the
ETHERNET FULL DUPLEX CONFIGURATION menu item and
press ENTER. The Ethernet Full Duplex Configuration screen displays.