Sears 113.298141 - Manual (Page 22)

REMOVING AND INSTALLING SAWBLADE.
WARNING: FOR YOUR OWN SAFETY, TURN
S W I T C H "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE REMOVING OR
INSTALLING SAWBLADE.
A Raise Blade Guard .. .remove insert.
B. To REMOVE blade, place a block of wood
against front of blade .. . P U L L arbor wrench
toward you to LOOSEN arbor nut WOOD BLOCK
BLADE GUARD NOT SHOWN FOR PIGTURE CLARITY
BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
C. To TlGHTEN arbor nut, .place a block of vyood
against rear of blade ... PUSH vvrench away
from you.
When installing the blade ... make sure the teeth are
pointing toward the front of the saw ... and that the
blade and collars are clean, and free from any burrs.
The HOLLOW side of the cpllar must be against the
blade. ,
Always tighten the arbor nut securely. -
NOTE: When using the Dado or Molding Head, it is not
necessary to install the loose collar.
To replace insert.
Place insert into insert opening in table and push
toward rear of saw to engage spring clip and until
keyslot in insert will drop over screw. Tighten screw.
Do not tighten screvv to the point where it will deflect
the insert. - . . : . ^ ^
TEETH POINTING TO
FRONT OF SAW
10
EXACT-I-CUT
The "yellow" plastic disc irribedded in the table in front
of the sawblade, is provided for marking the location of
the "sawcut" on the workpiece.
A. Check disc .. . if it is above table surface, place a
piece of hardwood on top of it and tap It down.
B. With blade 90° (square to table) cut off a piece of
wood. ^
C. Pull miter gauge back until wood is over disc. Using
very sharp pencil, mark a line on disc.
D. With rriiter gauge in right hand groove, follow same
procedure and mark another line on disc.
E. These lines indicate the "path" of the cut (kerf)
made by the sawblade.
F. When cutting the workpiece, line up mark on
Workpiece with line on disc.
.BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
1/
22