Sears 113.298141 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8.
Press guard onto support so that bottom of guard is
approximately 3/4 in. away from belt.
NOTE: To remove guard, lift up on LONG TABS of
clips . . . pull guard outward. The clips should remain
on the BELT GUARD SUPPORT.
PLUGGING IN MOTOR
1.
From among the loose parts, find two wire ties
2.
Route motor cord along right side of cabinet and snap
ties in 1/4" hole in side of cabinet. Secure two cords in
wire ties.
19