Sears 113.298141 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Lay REAR FENCE GUIDE BAR on table to act as a

straightedge. If outer edge of extension is higher or lower
than table surface;

Slightly loosen nuts holding bracket to extension

using 7/16 in. wrench.

B. Move end of extension up or down until outer edge

is even with table surface .;. check with GUIDE
BAR .. . tighten nuts,

Recheck INNER edge of extension to make sure It

has not moved ... readjust, if necessary.

INSTALLING RIP FENCE GUIDE BARS AND SWITCH
BOX

From among the loose parts find the following

hardware:

2 Hex. Head Screws, 5/16-18 x 1-3/4 in. long

2 Hex Head Screws, B/1G-18 X 1 in. long
1 Hex. Head Screw, 5/16-18 x 3/4 in, long
5 External Lockwashers, 5/16 in,
{approx, dia. of hole 5/16 in.)
5 Hex. Nuts, 5/16-18 (approx, día. of hole 5/16 in.)
2 Flat washers {dia. of hole 21/64 in.)
2 Spacers, 3/4

in. dia. X

1/2

in. long

2 Self threading nuts

1 Fence Guide Bar Rod

Lay guide bars on savi table.

NOTE: The various holes in the bar allow them to be
positioned on this saw and also makes them adaptable
to other models.

Insert a 1-3/4 in. long screw through the THIRD hole

from the LEFT IN THE FRONT BAR . . . insert
another 1-3/4 in. long screw through a flat washer and

then through the hole at EXTREME LEFT SIDE OF
SWITCH then through SEVENTH hole in bar. Hold
them in place with a piece of masking tape . . . Insert
the 3/4 in. long screw through a flat washer and then
through hole at RIGHT SIDE OF SWITCH and then
through the EIGHT hole jn bar. Install a lockwasher
and nut and tighten. ■ r ;

Place spacers on screws.

Insert bolts through holes in middle and on right side of

front of savv table ... install lockwa^ers and nuts.
DONT SCREW NUTS ON ALL THE WAY, just get
them started on the screws.

6. Remove the 3 screws from rear of table extension.

7. Insert 1 in, long screws in SECOND and FOURTH holes

of rear bar arid attach to table the sanie way.

8. Insert ends of FENCE GUIDE BAR ROD through

round holes at outer end of bars.

NOTE: The ends of the ROD are not threaded ... the

SELF THREADING NUTS will cut threads on the rod

as they are screwed on.