Carrier 48TJ016-028 - Manual (Page 6)

T T P ( 4 1 P L C S ^
0 ' - 3 ? / 8 '
1 3/8* 8iA. 08AIM HOLE
UNIT
STD UNIT
WEIGHT
ECONOMIZER
WEIGHT
CORNER
A
CORNER
B
CORNER
C
CORNER
D
DIMA DIM B DIMC
lb kg lb kg lb kg lb kg lb kg lb kg ft-in. mm ft-in. mm tt-in. mm
48TJD,
TJF024
1850 839 90 41 443 201 406 184 476 216 525 238 3-2 965 3-5 1041 1-8 508
48TJD,
TJF028
2000 907 90 41 471 214 428 194 526 239 574 260 3-2 965 3-5 1041 1-8 508
NOTES:
1. Refer to print for roof curb accessory dimensions.
2, Dimensions in ( ) are in millimeters.
3^ Center of Gravity.
Direction of airflow.
5. Ductwork to be attached to accessory roof curb only.
6. Minimum clearance:
• Rear: 7'-0" (2134) for coil removal. This dimension can be reduced to
4'-0" (1219) if conditions permit coil removal from the top.
• 4'-0" (1219) to combustible surfaces, all four sides (includes between
units).
' Left side: 4'-0" (1219) for proper condenser coil airflow.
' Front: 4'-0" (1219) for control box access.
• Right side: 4'-0" (1219) for proper operation of damper and power
exhaust if so equipped.
• Top: 6'-0" (1829) to assure proper condenser fan operation.
' Bottom: 14" (356) to combustible surfaces (when not using curb).
' Control box side: 3'-0" (914) to ungrounded surfaces, non-combustible.
• Control box side: 3'-6" (1067) to block or concrete walls, or other
grounded surfaces.
• Local codes or jurisdiction may prevail.
7. With the exception of clearance for the condenser coil and the damper/
power exhaust as stated in Note #6, a removable fence or barricade
requires no clearance.
8. Dimensions are from outside of corner post. Allow O'-^/ie" (8) on each
side for top cover drip edge.
SECTfON A-A
Fig. 5 — Base Unit Dimensions; 48TJ024,028