Winco DSE71xx Series - Manual (Page 44)

DSE Model 71xx Series Control & Instrumentation System Mk2 Operators Manual
44 Part No. 057-113 71xx Series OPERATING MANUAL ISSUE 2 12/08/2010 ADM
CONFIGURATION PARAMETERS – ENGINE (Page 8) 7110 7120
MPU CAN MPU CAN
801 Magnetic pickup fitted On (1), Off (0) X X
802 Flywheel teeth 000 X X
803 Start Attempts 0
804 RESERVED
805 RESERVED
806 Gas choke timer (Gas engine only) 0:00 X X
807 Gas on delay (Gas engine only) 0:00 X X
808 Gas ignition off delay (Gas engine only) 0:00 X X
809
Crank disconnect on Oil pressure
enable
On (1), Off (0)
810 Check oil pressure prior to starting On (1), Off (0)
811 Crank disconnect on Oil pressure 0.00 Bar
812 Crank disconnect on frequency 0.0Hz
813 Crank disconnect on Engine Speed 000 rpm
814 Under speed enable On (1), Off (0)
815 Under speed shutdown 0000 rpm
816 Over speed shutdown 0000 rpm
817 Low battery volts enable On (1), Off (0)
818 Low battery volts warning 00.0 V
819 Low battery volts return 00.0 V
820 Low battery volts delay 0:00:00
821 High battery volts enable On (1), Off (0)
822 High battery volts return 00.0 V
823 High battery volts trip 00.0 V
824 High battery volts delay 0:00:00
825 Charge alt shutdown enable On (1), Off (0)
826 Charge alt shutdown trip 00.0 V
827 Charge alt shutdown delay 0:00:00
828 Charge alt warning enable On (1), Off (0)
829 Charge alt warning trip 00.0 V
830 Charge alt warning delay 0:00:00
831 Low battery start arming
On (1), Off (0)
832 Low battery start threshold 00.0 V
833 Low battery start delay 0:00:00
834 Low battery start run time 0:00:00