8front panel configuration – Winco DSE71xx Series User Manual

Page 36

DSE Model 71xx Series Control & Instrumentation System Mk2 Operators Manual

Part No. 057-113 71xx Series OPERATING MANUAL ISSUE 2 12/08/2010 ADM

FRONT PANEL CONFIGURATION

This configuration mode allows the operator limited customising of the way the module operates.
All available parameters can be adjusted by this method, or alternatively by using the optional DSE Configuration Suite
Software for Windows PC in conjunction with a USB A-B cable. Full details of this are contained in the 71xx Configuration Suite
Software Manual.

Use the module’s navigation buttons to traverse the menu and make value changes to the parameters:

NOTE: - The editor automatically exits after 5 minutes of inactivity to ensure security.

8.1 ACCESSING THE MAIN FRONT PANEL CONFIGURATION EDITOR

Ensure the engine is at rest and the module is in STOP mode by pressing the Stop/Reset

button.

Press the Stop/Reset

and Info

buttons simultaneously

8.1.1 EDITING A PARAMETER

Enter the editor as described above

Press the

(left) or

(right) buttons to cycle to the section you wish to view/change.

Press the

(up or down) buttons to select the parameter you wish to view/change within the currently

selected section.

To edit the parameter, press

to enter edit mode. The parameter begins to flash to indicate that you are editing

the value.

Press the

(up or down) buttons to change the parameter to the required value.

Press

to save the value. The parameter ceases flashing to indicate that it has been saved.

To exit the editor at any time, press and hold the

button

NOTE: - When the editor is visible, it automatically closes after 5 minutes of inactivity to ensure security.

NOTE: - Values representing pressure are displayed as Bar, kPa and PSI. Values representing temperature are

displayed as degrees Celsius and Degrees Farenheit.

Increase

Decrease