Parameter details – Viconics VT8300 Low Voltage User Interface Guide User Manual
Page 10
10
Viconics Technologies Inc.
|
9245 Langelier Blvd.
|
St.-Leonard
|
Quebec
|
Canada
|
H1P 3K9
|
Tel: (514) 321-5660
|
Fax: (514) 321-4150
028-0427-01
www.viconics.com
|
November 2014
©
2
01
4 V
ic
onic
s T
ec
hno
lo
gi
es
Inc
. A
ll r
ig
ht
s r
ese
rv
ed
.
VT8300 Series
User Interface Guide
LUA GENERIC PARAMETERS
The LUA settings include six generic parameters that do not have predefined values. These can be used to represent LUA script variables.
They are user configurable in their default state, but when they are assigned a value by a LUA script they become read only, and the
display colour of the parameter changes to red. These parameters are also modifiable through BACnet as Analog Values (AVs). These
parameters can be configured to receive information from ZigBee sensors.
3/3 LUA
0
8
Param. B (AV26)
Param. C (AV27)
Param. D (AV28)
Param. E (AV29)
Param. F (AV30)
0
0
0
Param. A (AV25) 5
A parameter defined by a LUA
script displays in red text.
The default value is normally 0,
but it can be user-configured to
use a different default value.
PARAMETER DETAILS
Configuration Parameters Default Value
Significance and Adjustments
Parameter A
Default value: 0
Default value can be changed by user
AV25
The value(s) of this parameter depends on what is assigned to it
using the LUA script function
Parameter B
Default value: 0
Default value can be changed by user
AV26
The value(s) of this parameter depends on what is assigned to it
using the LUA script function
Parameter C
Default value: 0
Default value can be changed by user
AV27
The value(s) of this parameter depends on what is assigned to it
using the LUA script function
Parameter D
Default value: 0
Default value can be changed by user
AV28
The value(s) of this parameter depends on what is assigned to it
using the LUA script function
Parameter E
Default value: 0
Default value can be changed by user
AV29
The value(s) of this parameter depends on what is assigned to it
using the LUA script function
Parameter F
Default value: 0
Default value can be changed by user
AV30
The value(s) of this parameter depends on what is assigned to it
using the LUA script function