Tuffy Security 240 - Manual (Page 10)

Page 10 of 10 - 122006 – Rev 070811
40. Close the lid #1. The welded studs on the lid #1 with bolts #10.1 located toward the rear of the vehicle should now
overlap the end of the side panels. Push the lid toward the front of the vehicle till it stops while guiding the welded
studs into the slots on the side panels #3 and #4. When the rear vehicle door is shut it prevents the lid from being
pulled toward the rear releasing it from the slots. When the rear vehicle door is locked so is the Tuffy enclosure. (See
Figure 7)
Figure 7
41. Check the seal between the vehicle rear door and the lid. Close the top rear window and check the clearance with the
lid. Loosen the mounting hardware and maneuver the enclosure so there is a good seal and clearance between the
top rear window if necessary.
Call (970) 564-1762 for Technical Support