Tuffy Security 131 - Manual

Page 1 of 2 - 1/28/2008 – Rev122006
INSTALLATION INSTRUCTIONS
DRAWERS #131
Please read and fill out the enclosed warranty registration card to activate your warranty.
SHIPMENT CONTENTS
(1) Drawer Enclosure (1) Drawer (1) Left Panel (1) Right Panel Handle
HARDWARE PACKAGE
(2) 7/16 x 2” Hex Bolts G8 (2) 3/8 x 1 ½” Hex Bolts G8 (6) 5/16” x ¾ Hex Bolts
(6) 5/16” Washers (2) 3/8” Washers (2) 7/16” Washers ¼-20 Nut
PLEASE READ ALL SAFETY WARNINGS AND INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALL
INSTALLATION
NOTICE!
DRAWER WILL HAVE TO BE REMOVED FOR INSTALLATION
INSTRUCTIONS FOR REMOVING DRAWER
Before attempting to install your new Tuffy Drawer, it is necessary to remove the drawer from the
body. To do this, pull the drawer out as far as it can go then locate the small black plastic stops
visible on the ball bearing drawer slides. One of the black stops will need to be deactivated by
pressing down and the other one pulled up. Be careful not to break plastic stops. While deactivating
the stops pull the drawer out and the slides will separate. When you are finished installing your
drawer, line up the slides and push the drawer back in.
1. Install the drawer handle using (2) ¼-20 nuts.
2. Fasten both the right and left mounting panels to the drawer enclosure. ATTENTION: There are four options of mounting
hole locations. Use the lowest holes for the minimum clearance under the drawer. Use the highest holes for the maximum
clearance under the drawer which will enable the storage of items such as the soft windows. (See Figure 2)