Tuffy Security 139 User Manual
Attention, Installation instructions

Page 1 of 3 - 06/23/2008 – Rev02152006
INSTALLATION INSTRUCTIONS
JEEP JK SECURITY CONSOLE INSERT #139
Call (970) 564-1762 for Technical Support
Please read and fill out the enclosed warranty registration card to activate your warranty.
PARTS CHECKLIST
(2) 5/16-18 x 4 1/2” HEX CAP SCREW, GRADE 8
(2) 5/16-18 HEX NYLON INSERT NUTS
¼” SELF TAPPING SCREW (4) 5/16” WASHERS (10) #6 WASHERS (14) #6-32X¾” SCREW RUBBER SEAL
TOOLS NEEDED
• T-20 Torx bit or wrench (To remove OEM console)
• T-30 Torx bit or wrench (To remove OEM console)
• Flat Head Screwdriver (If OEM console has electric window switches in the rear)
• 5/64” Allen bit or wrench
• 3/8” socket for drill to insert self tapping screw
Tools for optional additional mounting security
• Electric
drill
• 3/8” Drill bit
• Marker or pencil
• Silicone sealant (Recommended)
• ½” Socket and ratchet
• ½”
Wrench
ATTENTION:
FREQUENT LUBRICATION IS NECESSARY ON THE LOCKING SYSTEM
The pushbutton lock contains an “O” ring seal to protect the interior from dust and water. If this mechanism is not lubricated regularly
it will become difficult to operate and it may not return to its home position preventing the key from operating the lock. If this
happens simply pull up on the pushbutton to manually bring it back to its home position. Lubricate the pushbutton with a light
lubricant such as silicone spray. The pushbutton may have to be periodically disassembled and cleaned.