Top Flite TOPA0704 - Manual (Page 10)

10
❏ ❏
4. On the top of the wing center section there is
a hole located at the front of the wing where you will
fi nd a string attached. Gently pull the string that the
air line is attached to, pulling the air line out of the hole.
Do not pull too hard causing the string to break! If
the lines get caught on a rib while pulling the air line
through the wing, pull the air line and string back out,
re-position where the string is taped to the lines and
try pulling the line through again. Should you break the
string it will be very diffi cult to feed a new string into the
wing. Tape the air line to the top of the wing to prevent
the lines from falling back into the wing.
❏
5. Repeat this for the left side of the wing.
❏ ❏
6. Install each of the two air lines onto the air in /
out ports on the air cylinder. Make note of which color
air line you install on each so that you install them the
same way when installing the remaining landing gear.
❏ ❏
7. Place the landing gear on the landing gear rails.
Manually move the landing gear leg up and down. You
will see that the air cylinder moves forward and aft when
the leg moves. The landing gear is properly positioned
on the rails when you can move the landing gear leg
up and down without the air line being pinched at the
back of the cylinder against the wing spar.
❏ ❏
8. Double check your placement of the landing
gear on the rails, then use a 1/16" [1.6mm] drill bit to
drill a pilot hole through each of the mounting holes in
the landing gear mounting plates and into the hardwood
mounting rails.