Top Flite TOPQ8412 - Manual

PARTS LIST
These are the parts included in this kit.
❏
Instrument panel
❏
Upper side panels (L & R)
❏
Lower side panels (L & R)
❏
Floor
❏
Back rest
❏
Control panels (L & R)
❏
Seat
❏
Instrument panel decal
❏
Details package (pins, elastic strap for seat belt,
dowel for control stick)
SUGGESTED TOOLS & SUPPLIES
❏
Curved-tip scissors suitable for cutting plastic
(HCAR0667)
❏
Hobby knife and #11 blade
❏
Sandpaper and sanding tools
❏
Airbrush (if preferred)
❏
Paint brushes
❏
Paint (acrylic or enamel recommended)
❏
Clear RTV silicone or Shoe Goo
❏
Thick or medium CA
❏
Sheet of leftover 1/16" [1.6mm] or 3/32" [2.4mm]
balsa
ASSEMBLY
Note: After cutting out the parts when instructed to do so,
true the edges with a sanding block with 80-grit sandpaper.
Test fit each part in the model, so that the next part can be
fit to it.
Refer to the sketch and photo while assembling and
installing the cockpit kit.
❏
1. Cut out the instrument panel. Use a hobby knife with
a #11 blade or a rotary tool with a cutting bit to cut out the
BACK REST
SEAT
LEDGE
(INSTRUMENT PANEL NOT SHOWN)
UPPER SIDE PANEL
CONTROL PANEL
LOWER SIDE PANEL
FLOOR
SCALE COCKPIT KIT – ASSEMBLY INSTRUCTIONS
Thank you for purchasing a Top Flite ® Sea Fury scale cockpit
interior. The parts in this kit represent an interior from
drawings and photos of a full-size Sea Fury. Not all Sea
Fury’s have the exact same cockpit layout so, if necessary,
modifications could be made to this kit to make it exactly like
the one in your documentation. If precision authenticity is not
a priority, simply follow these instructions to end up with a
scale-looking cockpit interior that will really put the finishing
touches on your model. The parts in this kit must be painted
with a paint that is compatible with styrene (Top Flite
LustreKote
® is not suitable for styrene). Since the cockpit is
inside the model, fuelproof paint is not necessary. Acrylic
paints found in craft stores can be purchased in a wide
variety of colors and in small containers. Small details such
as switches, knobs, dials, etc. can be applied with a paint
brush, but, if possible, the main coat should be applied with
an airbrush for the best results.
Replacement parts may be ordered as listed below
through your hobby shop, through Product Support
(telephone: 217-398-8970, fax: 217-398-7721) or
online at: www.top-flite.com. For accuracy, be
certain to include the part numbers when ordering.
❏
SEA6CK01 Left upper side panel, left lower side
panel, seat
❏
SEA6CK02 Instrument panel, floor, back rest
❏
SEA6CK03 Right upper side panel, right lower side
panel, L & R control panels
❏
SEA6CKP02 Decal
❏
TAPE002 Elastic strap