TC-Helicon VoiceLive 3 - Reference Manual User Manual
Page 94
VoiceLive 3 – Reference manual (2014-03-29) 92
Lead Mute parameter
Use the Lead Mute parameter to mute all incom-
ing lead vocal signals.
Parameter settings: on/off.
When Lead Mute is on, it mutes either micro-
phone or line level signals, whichever is plugged
into the combo jack. Lead Mute is great for “post
processing” prerecorded dry vocals.
Post processing prerecorded dry vocals:
– Send the “dry” vocal from your DAW to the
Mic/Line input.
– Turn Lead Mute on.
– Record the resulting effects-only signal to a
new track in your DAW.
– Blend the original “dry” vocal track and new
“wet” vocal tracks together in the mix.
Aux Level parameter
Use the Aux Level parameter to control the level
of the signal received at the Aux input jack. If you
are getting distortion when connecting an exter-
nal music source to the Aux input, try turning this
control down.
Aux Vocal Cancel parameter
When you activate Aux Vocal Cancel, Voice-
Live 3 will attempt to remove vocals from re-
corded stereo music coming into the Aux input.
Please note that the ability for Voice Cancel to
“work its magic” is highly dependent on the mix
of the incoming music. Stereo recordings with
vocals directly in the middle and instruments
panned far to the left and right tend to work the
best.